If you do not control, in the previous article - such as cleaning the case, the time has come to do this. Look at the rotor blades of the fan at the back of the computer. Create all ventilation shafts. Are there groups of dust? Are there any lumps in the dirt on him? If so, within to be cleaned. If the blades of the fan are clean, but it has been for several years that the motherboard cleaned or, if the computer in the magnitude of cigarette smoke, it should probably be cleaned anyway. Dust and particles in the air (such as cigarette smoke) may be based on the circuits of the main board and because of the heat and / or corrode.
The first thing you have to do is to consult your computer. Then open the case, access to the motherboard. Otherwise the case open. If you do not know how your case, you will see on the back of the computer on the edge of some screws. These screws May influence on the side panels or upside down U-shaped table, in the sides and at the top. Remove the screws you can take off the lid. Other cases are the screws on the front of the computer. In order to have access to these screws, you must first remove the front panel by clicking on a bar hidden. The coverage is to give access to your computer if you are strong enough, you should know how to remove it.
Remember, if you have nothing to tap into the motherboard, you should be grounded by one of the two, touch the metal chassis of the computer with the other hand, or by wearing a special device on earth.
The goal of cleaning the motherboard, all dust and debris on the main board of the Interior and for all components of the case. This can be done by using the three methods.
The best method is to use a can of compressed air to skip. Always keep in a right position to prevent the chemicals, the propeller damage, or damage to the components. Dust and dirt are blown, the motherboard, into and out of the thing.
Another way to remove dust, is a vacuum. The advice is to use only one battery, as a gap AC causes static and static can spoil the main board. I have a gap AC (before I knew that this is not recommended) for cleaning my mother ever again, and it has never caused problems, but I was lucky in May. If the gap, hold the nozzle a pair of customs on the board or other component, so that they are not with them in contact and for all that the small coins are not removed in a vacuum.
If you are not a box with compressed air or an empty, you can use a dry cloth and brushes for cleaning the main board. Be careful not to displace or break something with this method.
Although the board cleaning it, not separate or cable connections to displace or lose everything elements, as the riders.
Méthodiquement cleaning throughout the case currently on the entire motherboard from one end to another, and all other components. Do not forget to clean the fans and the Fountain of the heat. Do not open, food or whatever on the floor of the fan. If you do, you get a shocking surprise and the ruin of your computer.
If your computer does not work when you are back at the same time, is of course a bit crowded during the cleaning. Open the case and do all the connections and the cards in their niches. Search for everything May were separated.
Cleaning the board is probably the most dangerous form of cleaning, but it is necessary to prevent the premature death of your computer.